Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC Descriptors
- DTC B1370 01
-
Device Ignition 1 (ON and START) Circuit Short to Battery
- DTC B1370 06
-
Device Ignition 1 (ON and START) Circuit Short to Ground or Open
- DTC B1380 01
-
Device Ignition ACCESSORY Circuit Short to Battery
- DTC B1380 06
-
Device Ignition ACCESSORY Circuit Short to Ground or Open
- DTC B1440 00
-
Power Mode Master Input Circuits Mismatch
- DTC B1441 01
-
Device Ignition OFF, RUN, and CRANK Circuit Short to Battery
- DTC B1441 06
-
Device Ignition OFF, RUN, and CRANK Circuit Short to Ground or Open
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.