Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011SAVANA SPECIAL 4.8 AREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 174 (FRONT SUSPENSION SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2011 GMC Savana Special 4.8 A
Fastener Tightening Specifications
2011 GMC Savana Special 4.8 ASECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2011 GMC Savana and 2011 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Brake Hose Bracket to Steering Knuckle Bolt | 10 N.m | 88 lb in |
| Brake Hose Bracket to Upper Control Arm Bolt | 10 N.m | 88 lb in |
| Hub and Bearing to Steering Knuckle Mounting Bolts | 180 N.m | 133 lb ft |
| Lower Ball Joint Retaining Nut | 100 N.m | 74 lb ft |
| Lower Control Arm to Frame Mounting Nuts | ||
|
155 N.m | 114 lb ft |
|
120 N.m + 175° | 89 lb ft + 175° |
|
120 N.m + 175° | 89 lb ft + 175° |
| Outer Tie Rod Retaining Nut | 63 N.m | 47 lb ft |
| Shock Absorber Lower Retaining Bolts | ||
|
25 N.m | 18 lb ft |
|
80 N.m | 59 lb ft |
| Shock Absorber Upper Retaining Nut | 22 N.m | 16 lb ft |
| Stabilizer Shaft Insulator Clamp | ||
|
25 N.m | 18 lb ft |
|
50 N.m | 37 lb ft |
|
25 N.m | 18 lb ft |
| Stabilizer Shaft Link Bolt | 11 N.m | 97 lb in |
| Torsion Bar Support Mounting Bolts | 95 N.m | 70 lb ft |
| Upper Ball Joint Retaining Nut | 50 N.m | 37 lb ft |
| Upper Control Arm Mounting Nuts | 175 N.m | 129 lb ft |
| Wheel Drive Shaft Nut | 210 N.m | 155 lb ft |
| Wheel Speed Sensor Retaining Bolt | 18 N.m | 13 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.