Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011SAVANA SPECIAL 4.8 AREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 171 (ENGINE COOLING SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC P00B6CIRCUIT/SYSTEM VERIFICATION
2011 GMC Savana Special 4.8 A
Circuit/System Verification
2011 GMC Savana Special 4.8 ASECTION Circuit/System Verification
WARNING: This page is about a different car, the 2011 GMC Savana and 2011 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, observe the DTC information with a scan tool. DTC P00B3, P00B4, P0117, or P0118 should not be set.
- If a DTC is set, refer to Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.
- Verify the coolant in the radiator surge tank is at the correct level and there are no engine coolant leaks.
- Engine idling for 15 min with the A/C OFF.NOTE:
Depending on ambient temperature, it may take up to 4 min for the temperatures to equalize.
- Increase the engine speed to 3 000 RPM. Observe the scan tool RCT and the ECT sensor parameters. The RCT and the ECT sensor parameters should be within 20°C (68°F).
- Operate the vehicle within the conditions for running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.