Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2011 GMC Savana Special 4.8 ASECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 GMC Savana Special, 2010 GMC Savana Camper Special, 2010 GMC Savana, 2010 Chevrolet RV Cutaway, and 2010 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the instrument cluster panel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
- Remove the screws (2) that secure the radio to the support bracket (1).
- Remove the radio from the support bracket enough to access the connectors at rear of the radio.
- Disconnect the electrical/audio and antenna cable connectors from the radio.
- Remove the radio.
- If removing the radio mounting bracket. Perform the following steps:
- Detach the clip retaining the HVAC harness to the radio mounting bracket.
- Remove the screws (2) retaining the radio mounting bracket (1) to the instrument panel carrier.
- Remove the radio mounting bracket from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.