Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011SAVANA SPECIAL 4.8 AREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 14 (DATA COMMUNICATION SYSTEM)DIAGNOSTIC INFORMATION & PROCEDURESSCAN TOOL DOES NOT COMMUNICATE WITH LOW SPEED GMLAN DEVICECIRCUIT/SYSTEM TESTINGTESTING THE SERIAL DATA CIRCUIT FOR AN OPEN/HIGH RESISTANCE
2011 GMC Savana Special 4.8 A
Testing the Serial Data Circuit for an Open/High Resistance
2011 GMC Savana Special 4.8 ASECTION Testing the Serial Data Circuit for an Open/High Resistance
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 GMC Savana Special, 2010 GMC Savana Camper Special, 2010 GMC Savana, 2010 Chevrolet RV Cutaway, and 2010 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the appropriate harness connectors at the JX 200 splice pack.
- Install a 3 A fused jumper wire between the disconnected splice pack connector terminal 1 and a low speed GMLAN serial data circuit terminal that is not communicating.
- Ignition ON, verify the scan tool communicates with the control modules connected to the low speed GMLAN serial data circuit.
- If any control module does not communicate, test each section of the serial data circuit for an open/high resistance. If the circuits test normal, replace the control module that does not communicate when connected.
- If all circuits test normal, replace the splice pack.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.