Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSGMC2011SAVANA SPECIAL 4.8 AREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTING SYSTEMREPAIR INSTRUCTIONSREAR FOG LAMP SWITCH REPLACEMENTINSTALLATION PROCEDURE

2011 GMC Savana Special 4.8 A

Installation Procedure

2011 GMC Savana Special 4.8 ASECTION Installation Procedure

Fig 1: Rear Fog Lamp Switch

Courtesy of GENERAL MOTORS CORP.

Install the following components to the instrument panel extension:
- The rear fog lamp switch
- The bezel
Apply pressure to the rear fog lamp switch in order to engage the tabs on the switch to the bezel.
Install the rear fog lamp switch.

Fig 2: Instrument Panel Extension Bezel

Courtesy of GENERAL MOTORS CORP.

Install the electrical connector to the rear fog lamp switch.
Install the bezel to the lower panel extension.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.