Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011SAVANA SPECIAL 4.8 AREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTING SYSTEMREPAIR INSTRUCTIONSFRONT POSITION LAMP REPLACEMENTREMOVAL PROCEDURE
2011 GMC Savana Special 4.8 A
Removal Procedure
2011 GMC Savana Special 4.8 ASECTION Removal Procedure
- Remove the screws holding the retaining ring to the headlamp housing assembly.
- Remove the retaining ring from the position lamp.
- Remove the headlamp capsule (1) from the position lamp.
- Remove the bulb (4) and socket from the rubber grommet in the lamp capsule.
- Push in on the side of the bulb (4) and turn the bulb 1/4 turn counterclockwise.
- Remove the bulb (4) from the socket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.