SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011SAVANA G2500, VAN CARGO, 6.0 GREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - FUEL INJECTOR 6 THROUGH YAW SENSORCOMPONENT CONNECTOR END VIEWSWINDOW SWITCH - PASSENGER (A31)
2011 GMC Savana G2500, Van Cargo, 6.0 G

Window Switch - Passenger (A31)

2011 GMC Savana G2500, Van Cargo, 6.0 GSECTION Window Switch - Passenger (A31)
Fig 1: Connector End View Window Switch - Passenger (A31)
GM333036Courtesy of GENERAL MOTORS CORP.
Window Switch - Passenger (A31)

Pin Wire Circuit Function
A 3 D-GN 1001 RAP 12-Volt Fuse Control
B 0.35 BN/WH 230 Instrument Panel Lamps Dimming Control
C 0.35 BK 1850 Ground
D 3 TN 167 Power Window Master Switch Right Front Down Signal
E - - Not Used
F 3 BN 667 Power Window Motor Right Front Down Control
G 3 D-BU 666 Power Window Motor Right Front Up Control
H 3 L-BU 166 Power Window Master Switch Right Front Up Signal
Connector Part Information
  • Harness Type: Passenger Door
  • OEM Connector: 12191825
  • Service Connector: 15306048
  • Description: 8-Way F Metri-Pack 280 Series (BN)
Terminal Part Information
  • Terminated Lead: Pins: A, D, F-H - 13575756
  • Terminated Lead: Pins: B-C - 13575753
  • Release Tool: J-38125-553
  • Diagnostic Test Probe: J-35616-4A (PU)
  • Terminal/Tray: Pins: A, D, F-H - 15304713/19
  • Terminal/Tray: Pins: B-C - 15304711/8
  • Core/Insulation Crimp: Pins: A, D, F-H - F/D
  • Core/Insulation Crimp: Pins: B-C - E/A
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.