Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011SAVANA G2500, VAN CARGO, 6.0 GREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKESANTILOCK BRAKE SYSTEMREPAIR INSTRUCTIONSVEHICLE YAW SENSOR WITH VEHICLE LATERAL ACCELEROMETER REPLACEMENTINSTALLATION PROCEDURE
2011 GMC Savana G2500, Van Cargo, 6.0 G
Installation Procedure
2011 GMC Savana G2500, Van Cargo, 6.0 GSECTION Installation Procedure
- Install the yaw rate sensor and lateral accelerometer (1) to the vehicle.
- Install the yaw rate sensor and lateral accelerometer nuts (2) and tighten to 9 N.m (80 lb in).
- Install a scan tool.
- Using the special functions menu on the scan tool, reset the yaw rate sensor.
- Perform the Diagnostic System Check. Refer to Diagnostic System Check - Vehicle .
- Connect the electrical connector (3) to the yaw rate sensor and lateral accelerometer.
- Install the carpet.
- Install the passenger seat to the vehicle. Refer to Driver or Passenger Seat Replacement .
CAUTION:
Refer to Fastener Caution .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.