Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011SAVANA G2500, VAN CARGO, 6.0 GREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEIGNITION SWITCH/STEERING LOCKWIRING SYSTEMS AND POWER MANAGEMENT - DTC DIAGNOSTICS, TROUBLESHOOTING AND CONNECTOR REPAIRDIAGNOSTIC INFORMATION AND PROCEDURESMOLEX CONNECTORSTERMINAL INSERTION PROCEDURE
2011 GMC Savana G2500, Van Cargo, 6.0 G
Terminal Insertion Procedure
2011 GMC Savana G2500, Van Cargo, 6.0 GSECTION Terminal Insertion Procedure
After the terminal is replaced, perform the following procedure in order to insert the terminal.
- Slide the new terminal into the correct cavity at the back of the connector.
- Push the terminal into the connector until it locks into place. The new terminal should be even with the other terminals. Insure that the terminal is locked in place by gently pulling on the wire.
- To assemble the connector, reverse the connector disassembly procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.