Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011SAVANA G2500, VAN CARGO, 6.0 GREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEATED GLASS/DEFOGGERSFIXED AND MOVEABLE WINDOWSDIAGNOSTIC INFORMATION AND PROCEDURESPOWER WINDOWS MALFUNCTIONCIRCUIT/SYSTEM VERIFICATION
2011 GMC Savana G2500, Van Cargo, 6.0 G
Circuit/System Verification
2011 GMC Savana G2500, Van Cargo, 6.0 GSECTION Circuit/System Verification
- Ignition ON, command the driver window UP and DOWN using the driver window switch. The driver window should perform the UP and DOWN functions.
- If the driver window does not perform the UP/DOWN function, refer to Driver Window Malfunction in Circuit/System Testing .
- Command the passenger window UP and DOWN using the RF window switch on the driver master control and the passenger door window switch. The passenger window should perform the UP and DOWN functions from each switch.
- If the passenger window does not perform the UP/DOWN function, refer to Front Passenger Window Malfunction in Circuit/System Testing .
- Command the express down of the driver door window by pressing the driver window switch past the first detent and releasing. The driver window should roll completely down.
- If the driver window fails to roll completely down, replace the driver window switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.