Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011SAVANA G2500, VAN CARGO, 6.0 GREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSENGINE CONTROL MODULE PROGRAMMING AND SETUP (RPO LMM)ECM REPLACEMENT
2011 GMC Savana G2500, Van Cargo, 6.0 G
ECM Replacement
2011 GMC Savana G2500, Van Cargo, 6.0 GSECTION ECM Replacement
If the engine control module (ECM) is replaced, the following procedures must be performed:
- Capture the Option data.
- Enable ECM Reprogramming-Refer to Service Programming System (SPS) .
- Restore the Option data in the new ECM.
- Start and idle vehicle.
- Using the scan tool, perform the Turbocharger Learn Procedure. Refer to Turbocharger Vane Position Sensor Replacement .
- Perform a Diesel Particulate Filter (DPF) Regeneration Enable .
- If necessary, perform the following:
- Theft Deterrent-Refer to Theft Deterrent Module Programming and Setup .
- The Fuel Injector Flow Rate Programming-Refer to Fuel Injector Flow Rate Programming .
- Engine Oil Life Remaining-Use scan tool to reset Engine Oil Life.
- Fuel Filter Life-Use scan tool to reset Fuel Filter Life.
NOTE:
Clear any DTCs that may have set after completing the programming procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.