SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011CANYON 4WD L4-2.9LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSSERVICE AND REPAIRREAR SIDE DOOR WINDOW SWITCH REPLACEMENT
2011 GMC Canyon 4WD L4-2.9L

Rear Side Door Window Switch Replacement

2011 GMC Canyon 4WD L4-2.9LSECTION Rear Side Door Window Switch Replacement



Rear Side Door Window Switch Replacement

Removal Procedure




1. Remove the 2 screws securing the switch plate assembly to the door trim panel.
2. Lift the switch plate up and out of the door trim panel.




3. Disconnect the electrical connectors from the switch module.
4. Remove the switch plate assembly from the vehicle.
5. If replacing only the switch module, remove the module from the switch plate.
6. If replacing only the switch plate, retain the switch module for transfer.

Installation Procedure




1. Install the switch module to the switch plate.
2. Connect the electrical connector to the switch module.





Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the rear switch plate assembly to the door trim panel with the 2 screws and tighten to 2 Nm (18 lb in).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.