Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011CANYON 4WD L4-2.9LREPAIR AND DIAGNOSISSTARTING AND CHARGINGBATTERYBATTERY TRAYSERVICE AND REPAIRBATTERY BOX REPLACEMENT
2011 GMC Canyon 4WD L4-2.9L
Battery Box Replacement
2011 GMC Canyon 4WD L4-2.9LSECTION Battery Box Replacement
Battery Box Replacement
Removal Procedure
1. Remove the battery. Refer to Battery Replacement (LLV/LLR) (Removal and Replacement)Battery Replacement (LH8) (Removal and Replacement).
2. Disconnect the following from the lower battery box (2):
* The battery cables harness retainer (3)
* The engine wiring harness retainer
3. Lift the lower battery box (2) upward from the battery tray (3).
Installation Procedure
1. Install the lower battery box (2) to the retainer stud (1) and battery tray (3).
2. Connect the following to the lower battery box (2):
* The battery cables harness retainer (3)
* The engine wiring harness retainer
3. Install the battery. Refer to Battery Replacement (LLV/LLR) (Removal and Replacement)Battery Replacement (LH8) (Removal and Replacement).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.