Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2011CANYON 4D PICKUP, 5.3 P, 4WDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMDATA COMMUNICATIONS SYSTEMREPAIR INSTRUCTIONSBODY CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE
2011 GMC Canyon 4D Pickup, 5.3 P, 4WD
Installation Procedure
2011 GMC Canyon 4D Pickup, 5.3 P, 4WDSECTION Installation Procedure
- Position the BCM to the vehicle.
- Attach the BCM to the hinge pillar with the integral tab.
- Install the 2 fasteners retaining the BCM to the hinge pillar.
- Install the fastener retaining the body wiring harness electrical connector to the BCM.
- Connect the body wiring harness electrical connector (1) to the BCM.
- Connect the remote control door lock receiver antenna wire to the BCM.
- Connect the I/P wiring harness electrical connector (1) to the BCM.
- Install the right front hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Right Side .
- If installing a replacement BCM, program the BCM. Refer to Control Module References .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.