Auxiliary Blower Control Module Replacement

2011 GMC Acadia SLT, FWDSECTION Auxiliary Blower Control Module Replacement
Fig 1: Locating Auxiliary Blower Control Module
GM1681989Courtesy of GENERAL MOTORS CORP.
Auxiliary Blower Control Module Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the right rear quarter trim panel. Refer to Quarter Lower Rear Trim Panel Replacement (Acadia with TB5) , Quarter Lower Rear Trim Panel Replacement (Traverse with TB5) , Quarter Lower Rear Trim Panel Replacement (Traverse with TB4) , Quarter Lower Rear Trim Panel Replacement (Enclave with TB5) , Quarter Lower Rear Trim Panel Replacement (Acadia with TB4) , Quarter Lower Rear Trim Panel Replacement (Enclave with TB4) .
  2. Disconnect the blower motor control module electrical connector.
1 Blower Motor Resistor Screw (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
1.5 N.m (13 lb in)
2 Blower Motor Control Module
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.