SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2010SAVANA SPECIAL 6.0 GREPAIR AND DIAGNOSISENGINE MECHANICALSTARTERBATTERY, CHARGING SYSTEM AND STARTING SYSTEMREPAIR INSTRUCTIONS (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)GENERATOR REPLACEMENT (LMM)REMOVAL PROCEDURE (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)
2010 GMC Savana Special 6.0 G

Removal Procedure (Battery, Charging System And Starting System)

2010 GMC Savana Special 6.0 GSECTION Removal Procedure (Battery, Charging System And Starting System)
  1. Disconnect the negative battery. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the upper fan shroud. Refer to Engine Coolant Fan Upper Shroud Replacement (4.3L, 4.8L, 5.3L, 6.0L, 6.2L, 7.0L) .
  3. Remove the drive belt. Refer to Drive Belt Replacement .
    4. Fig 1: View Of Auxiliary Generator & Bolts
    GM1369547Courtesy of GENERAL MOTORS CORP.
  4. Remove the generator bolts (1).
  5. Remove the generator front support bracket attached to the generator bracket and the generator.
  6. Reposition the generator to access wiring.
  7. Remove the positive battery cable nut from the generator.
  8. Disconnect the generator electrical connector.
  9. Remove the generator (2).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.