SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2010SAVANA SPECIAL 6.0 GREPAIR AND DIAGNOSISENGINE MECHANICALSTARTERBATTERY, CHARGING SYSTEM AND STARTING SYSTEMREPAIR INSTRUCTIONS (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)GENERATOR BRACKET REPLACEMENT (LGH)REMOVAL PROCEDURE (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)
2010 GMC Savana Special 6.0 G

Removal Procedure (Battery, Charging System And Starting System)

2010 GMC Savana Special 6.0 GSECTION Removal Procedure (Battery, Charging System And Starting System)
    WARNING: Refer to Battery Disconnect Warning .
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the fan assembly. Refer to fan replacement Fan Replacement .
    3. Fig 1: Identifying Engine Harness Retainer Nut & Engine Harness Ground Terminal Bolt
    GM2382164Courtesy of GENERAL MOTORS CORP.
  3. Remove the engine harness retainer nut (1) and engine harness ground terminal bolt (3). Reposition engine harness and ground terminal (2)..
  4. Reposition the oil level indicator tube. Refer to Oil Level Indicator Tube Replacement (LLY, LBZ) or Oil Level Indicator Tube Replacement (LMM)
  5. Remove the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .
  6. Remove the generator. Refer to Generator Replacement (V6)  or Generator Replacement (V8)  or Generator Replacement (LMM)  or Generator Replacement (LGH) .
    7. Fig 2: View Of Generator Bracket & Attachments
    GM2382166Courtesy of GENERAL MOTORS CORP.
  7. Remove the inlet pipe bracket bolts (1) from the generator bracket and the inlet manifold tube.
    8. Fig 3: Identifying Generator Bracket & Bolts
    GM2382167Courtesy of GENERAL MOTORS CORP.
  8. Remove the generator bracket nuts (1) and bolt (1) from the cylinder block. Remove the generator bracket (3).
  9. If replacing the generator bracket, remove the idler pulleys (4) and transfer to the new generator bracket.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.