Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2010SAVANA SPECIAL 6.0 GREPAIR AND DIAGNOSISENGINE MECHANICALSTARTERBATTERY, CHARGING SYSTEM AND STARTING SYSTEMREPAIR INSTRUCTIONS (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)AUXILIARY BATTERY NEGATIVE CABLE REPLACEMENT (LGH,LMM)REMOVAL PROCEDURE (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)
2010 GMC Savana Special 6.0 G
Removal Procedure (Battery, Charging System And Starting System)
2010 GMC Savana Special 6.0 GSECTION Removal Procedure (Battery, Charging System And Starting System)
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
- Disconnect the auxiliary battery negative cable from the auxiliary battery. Refer to Battery Negative Cable Disconnection and Connection .
- Disconnect the auxiliary battery negative ground bolt (1) from the frame.
- Remove the auxiliary battery negative cable (2) from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.