Instrument Panel/Center Console Component Views

2010 GMC Savana Special 6.0 GSECTION Instrument Panel/Center Console Component Views
Fig 1: Identifying Instrument Panel Components
GM1988217Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Driver Information Center (DIC) Switch
2 Turn Signal/Multifunction Switch
3 Steering Wheel Control Switch - Left (K34)
4 Instrument Panel Cluster (IPC)
5 Inflatable Restraint Steering Wheel Module
6 Steering Wheel Control Switch - Right (W1Y)
7 Instrument Panel
8 Tow/Haul Switch
9 HVAC Control Assembly
10 Radio
11 Inflatable Restraint I/P Module
12 Accessory Power Outlet - Center Console 2
13 Blower Motor Switch - Auxiliary (C36 without C69)
14 Inflatable Restraint I/P Module Indicator (Light Duty without YF7)
15 Inflatable Restraint I/P Module Disable Switch (C99)
16 Traction Control Switch (TCS) (JL4)
17 Cigar Lighter (DT4)/Accessory Power Outlet - Center Console 1 (without DT4)
18 Data Link Connector (DLC)
19 Headlamp and Panel Dimmer Switch
Fig 2: Locating Instrument Panel Harness Components
GM1973025Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Body Control Module (BCM)
2 Inflatable Restraint I/P Module
3 Ambient Light Sensor
4 Chime Module (UL5)
5 Remote Control Door Lock Receiver (RCDLR) (AU0)
6 Stop Lamp Switch
7 Accelerator Pedal Position (APP) Sensor
8 Park Brake Switch Pigtail Connector
9 Park Brake Switch
Fig 3: Identifying Upper Steering Column
GM2038323Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Theft Deterrent Module (TDM)
2 Ignition Key Alarm Switch
3 Ignition Switch
4 Ignition Key Cylinder
5 Horn Switch
6 Inflatable Restraint Steering Wheel Module
7 Turn Signal/Multifunction Switch
8 Hazard Warning Switch
Fig 4: View Of Steering Column
GM1965807Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 X200
2 Steering Wheel Speed/Position Sensor (JL4)
Fig 5: Identifying Air Temperature Actuator
GM2038337Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Air Temperature Actuator
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.