SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2010SAVANA SPECIAL 6.0 GREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTIGNITION SWITCH/STEERING LOCKWIRING SYSTEMS AND POWER MANAGEMENT - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSIGNITION LOCK CYLINDER REPLACEMENTINSTALLATION PROCEDURE
2010 GMC Savana Special 6.0 G

Installation Procedure

2010 GMC Savana Special 6.0 GSECTION Installation Procedure
    Fig 1: View of Ignition Cylinder Lock, Ignition Lock Cylinder Case Assembly and Upper Steering Column
    GM375309Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition lock cylinder by performing the following procedure:
    1. Align the positioning locking tab slot on the lock module to the positioning tab on the ignition lock cylinder.
    2. Push the lock cylinder in until the tab locks in the lock module.
  2. Install the steering column trim covers. Refer to Steering Column Trim Cover Replacement .
  3. Enable the SIR system. Refer to SIR Disabling and Enabling .
  4. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  5. Perform the Passlock learn procedure. Refer to Immobilizer System Component Programming .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.