Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Verification
2010 GMC Savana Special 6.0 GSECTION Circuit/System Verification
- Determine the control module that is not communicating. Refer to Control Module U Code List .
- Verify that DTC U1814, U2099, B1428, B1370, B1380, B1440, or B1441 is not set.
- If any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Engine running for 10 seconds.
- Ignition ON, engine OFF, verify that DTC U0100-U0299 is not set with symptom byte 00.
- If the DTC U0100-U0299 is set with symptom byte 00, refer to Circuit/System Testing below.
- Verify that DTC U0100-U0299 is not set with symptom byte 71 or 72.
- If the DTC U0100-U0299 is set with symptom byte 71 or 72 along with other DTCs set, diagnose all other codes first. Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If the DTC U0100-U0299 is set with symptom byte 71 or 72 and without other DTCs set, reprogram the control module. If the DTC resets, replace the control module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.