Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2010SAVANA SPECIAL 4.8 AREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTING SYSTEMREPAIR INSTRUCTIONSSTOP LAMP SWITCH REPLACEMENTREMOVAL PROCEDURE
2010 GMC Savana Special 4.8 A
Removal Procedure
2010 GMC Savana Special 4.8 ASECTION Removal Procedure
- Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
- Disconnect the electrical connector from the stop lamp switch.
- Remove the retainer from the brake pedal pin.
- Remove the stop lamp switch and the pushrod to the power brake booster from the brake pedal pin.
- Unsnap the stop lamp switch from the power brake booster pushrod.
WARNING:
Refer to Battery Disconnect Warning
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.