Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2010SAVANA G2500, VAN CARGO EXTENDED, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 31 (ENGINE MECHANICAL - 4.8L, 5.3L, 6.0L, 6.2L, OR 7.0L - SPECIFICATIONS)SPECIFICATIONSTHREAD REPAIR SPECIFICATIONSENGINE BLOCK - FRONT/REAR VIEWS
2010 GMC Savana G2500, Van Cargo Extended, 6.6 6
Engine Block - Front/Rear Views
2010 GMC Savana G2500, Van Cargo Extended, 6.6 6SECTION Engine Block - Front/Rear Views
WARNING: This page is about a different variant/trim than selected.
Engine Block - Front/Rear Views
| Hole | Thread Size | Insert | Drill | Counterbore Tool | Tap | Driver | Drill Depth - Maximum mm (in) | Tap Depth - Maximum mm (in) |
|---|---|---|---|---|---|---|---|---|
| J 42385- | ||||||||
| 1 | M8 x 1.25 | 210 | 206 | 207 | 208 | 209 | 22.5 (0.885) | 17.5 (0.688) |
| 2 | M10 x 1.5 | 215 | 211 | 212 | 213 | 214 | 27.5 (1.08) | 22.0 (0.866) |
| 3 | M10 x 1.5 | 215 | 211 | 212 | 213 | 214 | Thru | Thru |
| 4 | M8 x 1.25 | 210 | 206 | 207 | 208 | 209 | Thru | Thru |
| 5 | M10 x 1.5 | 215 | 211 | 212 | 213 | 214 | 25.0 (0.984) | 19.5 (0.767) |
| 6 | M10 x 1.5 | 215 | 211 | 212 | 213 | 214 | 32.5 (1.279) | 25.0 (0.984) |
| 7 | M10 x 1.5 | 215 | 211 | 212 | 213 | 214 | Thru | Thru |
| Bolt hole 6 is drilled and tapped for aluminum block applications only. | ||||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.