SYS.OK|MANUAL.DBâ—Ź LIVE
HOMESERVICE MANUALSGMC2010SAVANA G2500, VAN CARGO EXTENDED, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 908 (OBJECT DETECTION SYSTEM)COMPONENT LOCATOROBJECT DETECTION CONNECTORSREARVIEW CAMERA (UVC)
2010 GMC Savana G2500, Van Cargo Extended, 6.6 6

Rearview Camera (UVC)

2010 GMC Savana G2500, Van Cargo Extended, 6.6 6SECTION Rearview Camera (UVC)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rearview Camera (UVC) Connector End View
GM1334521Courtesy of GENERAL MOTORS CORP.
Rearview Camera (UVC) Connector Parts Information

Connector Part Information 
  • OEM: 15326827
  • Service: 89046648
  • Description: 5-Way M GT 150 Sealed (BK)
Terminal Part Information 
  • Pins: A-C
  • Terminal/Tray: 15326269/19
  • Core/Insulation Crimp: E/4
  • Release Tool/Test Probe: 15315247/J-35616-3 (GY)
  • Pins: D
  • Terminal/Tray: 15326269/19
  • Core/Insulation Crimp: E/1
  • Release Tool/Test Probe: 15315247/J-35616-3 (GY)
Rearview Camera (UVC) Connector Terminal Identification

Pin Wire Color Circuit No. Function
A OG 6201 Camera Supply Voltage
B TN/BK 6202 Camera Ground
C WH 6798 Camera Video Signal
D GY 7069 Camera Shield Extension
E - - Not Used
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.