Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2010SAVANA G2500, VAN CARGO EXTENDED, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2222 (ENGINE CONTROLS/FUEL - 5.3L, 6.0L, 6.2L - WIRING SCHEMATIC DIAGRAMS)
2010 GMC Savana G2500, Van Cargo Extended, 6.6 6
Section 2222 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - Wiring Schematic Diagrams)
2010 GMC Savana G2500, Van Cargo Extended, 6.6 6SECTION Section 2222 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - Wiring Schematic Diagrams)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Schematic Wiring Diagrams
- Engine Controls Wiring Schematics (Except LZ1)
- Module Power, Ground, Serial Data, and MIL Wiring Schematics
- Engine Data Sensors- 5-Volt and Low Reference Wiring Schematics
- Engine Data Sensors- Pressure and Temperature Wiring Schematics
- Engine Data Sensors- Oxygen Sensors Wiring Schematics
- Engine Data Sensors- Throttle Controls Wiring Schematics
- Ignition Controls- Ignition System Coils 1, 3, 5, and 7 Wiring Schematics
- Ignition Controls- Ignition System Coils 2, 4, 6, and 8 Wiring Schematics
- Ignition Controls- Sensors and Active Fuel Management Controls Wiring Schematics
- Fuel Controls- Fuel Pump Controls (L96) Wiring Schematics
- Fuel Controls- Fuel Pump Controls (except L96) Wiring Schematics
- Fuel Controls- Fuel Injectors Wiring Schematics
- Fuel Controls- EVAP Controls Wiring Schematics
- Controlled/Monitored Subsystem References Wiring Schematics
- Engine Controls Wiring Schematics (Except LZ1)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.