Communication Interface Module Bracket Replacement

2010 GMC Savana G2500, Van Cargo Extended, 6.6 6SECTION Communication Interface Module Bracket Replacement
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2011 GMC Savana Special, 2011 GMC Savana Camper Special, 2011 GMC Savana, 2011 Chevrolet RV Cutaway, and 2011 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Communication Interface Module Bracket
GM2532866Courtesy of GENERAL MOTORS CORP.
Communication Interface Module Bracket Replacement

Callout Component Name
Preliminary Procedure 
Remove the driver knee bolster. Refer to Driver Knee Bolster Replacement .
1 Communication Interface Module Bracket Bolt (Qty: 3)
CAUTION:

Refer to Fastener Caution .

2 Communication Interface Module Bracket

Procedure

  1. Disconnect the electrical connections.
  2. Transfer components as necessary.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.