Head Restraint Guide Replacement

2010 GMC Savana G2500, Van Cargo Extended, 6.6 6SECTION Head Restraint Guide Replacement
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Head Restraint Guide
GM1678363Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Front Seat Back Cushion Finish Panel
Tip:Β  Using a nylon flat-bladed tool, push the tabs in on the side of the panel to release from the seat back to remove.
2 Front Seat Head Restraint Assembly
Tip:Β 
  1. Depress the button on the inboard head restraint guide to raise the head restraint to the full up position.
  2. Insert a small diameter tool into the hole on the inboard side of the outboard head restraint guide and pull upward to remove.
3 Front Seat Head Restraint Guide (Qty: 2)
Tip:Β  Squeeze the bottom of the guide together and push up to remove from the seat back.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.