Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2010SAVANA G2500, VAN CARGO EXTENDED, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1506 (AUTOMATIC TRANSMISSION - 2ML70 - DTC P0218 TO DTC P0965-P0967)DTC P0634CIRCUIT/SYSTEM VERIFICATION
2010 GMC Savana G2500, Van Cargo Extended, 6.6 6
Circuit/System Verification
2010 GMC Savana G2500, Van Cargo Extended, 6.6 6SECTION Circuit/System Verification
WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that DTC P0563 is not set.
- If DTC is set, refer to DTC P0562 or P0563 .
- Ignition ON, observe the scan tool Trans. Fluid Temp. parameter. The reading should be less than 141°C (286°F).
- If greater than the specified range, test for a transmission overheat condition.
- Observe the scan tool TCM temperature parameter. The reading should be less than 141°C (286°F).
- If greater than the specified range, replace the control solenoid assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.