Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSGMC2010SAVANA G2500, VAN CARGO EXTENDED, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1478 (ENGINE CONTROLS AND FUEL - HYBRID (HP2) 6.0L (LFA) - INTRODUCTION (1 OF 2))REPAIR INSTRUCTIONSENGINE CONTROL MODULE REPLACEMENTREMOVAL PROCEDURE

2010 GMC Savana G2500, Van Cargo Extended, 6.6 6

Removal Procedure

2010 GMC Savana G2500, Van Cargo Extended, 6.6 6SECTION Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Engine Wiring Harness Electrical Connector & ECM

Courtesy of GENERAL MOTORS CORP.

Using a scan tool, retrieve the percentage of remaining engine oil. Record the remaining engine oil life.
Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (With Single Battery) or Battery Negative Cable Disconnection and Connection (With Auxiliary Battery) or Battery Negative Cable Disconnection and Connection (With Dual Batteries) .
Disengage the engine wiring harness electrical connector retainers and remove the connectors (2) from the ECM (1).

Fig 2: View Of Bracket Retainer Tabs, ECM Bracket & Tab

Courtesy of GENERAL MOTORS CORP.

Disengage the bracket retainer tabs (1) securing the ECM to the bracket.
Remove the ECM (3) from the bracket.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.