Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSGMC2010SAVANA G2500, VAN CARGO EXTENDED, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1478 (ENGINE CONTROLS AND FUEL - HYBRID (HP2) 6.0L (LFA) - INTRODUCTION (1 OF 2))REPAIR INSTRUCTIONSENGINE CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE

2010 GMC Savana G2500, Van Cargo Extended, 6.6 6

Installation Procedure

2010 GMC Savana G2500, Van Cargo Extended, 6.6 6SECTION Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Bracket Retainer Tabs, ECM Bracket & Tab

Courtesy of GENERAL MOTORS CORP.

Set the bottom of ECM into the ECM bracket tab (2).
Push the ECM (3) in securing the ECM to the bracket.

Fig 2: View Of Engine Wiring Harness Electrical Connector & ECM

Courtesy of GENERAL MOTORS CORP.

Position the engine wiring harness electrical connectors and engage the retainers securing the connectors (2) to the ECM (1).
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (With Single Battery) or Battery Negative Cable Disconnection and Connection (With Auxiliary Battery) or Battery Negative Cable Disconnection and Connection (With Dual Batteries) .
If a NEW ECM was installed, program the ECM. Refer to Control Module References .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.