SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2010SAVANA G2500, VAN CARGO EXTENDED, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1429 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)REPAIR INSTRUCTIONSCOMMUNICATION INTERFACE MODULE REPLACEMENT (WITHOUT RPO SLT)
2010 GMC Savana G2500, Van Cargo Extended, 6.6 6

Communication Interface Module Replacement (without RPO SLT)

2010 GMC Savana G2500, Van Cargo Extended, 6.6 6SECTION Communication Interface Module Replacement (without RPO SLT)
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View of Communication Interface Module (without RPO SLT)
GM1816359Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the instrument panel lower center panel. Refer to Instrument Panel Lower Center Trim Replacement .
1 Communication Interface Module
Tip: 
  • Push outward on the tab to release the communication interface module from the bracket.
  • Disconnect the electrical connectors.
  • Reprogram the communication interface module after replacement. Refer to Control Module References .
  • If replacing the communication interface module be sure to transfer Bluetooth Antenna, if equipped.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.