Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2010SAVANA G2500, VAN CARGO EXTENDED, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1044 (OBJECT DETECTION SYSTEM)REPAIR INSTRUCTIONSREAR OBJECT SENSOR REPLACEMENTINSTALLATION PROCEDURE
2010 GMC Savana G2500, Van Cargo Extended, 6.6 6
Installation Procedure
2010 GMC Savana G2500, Van Cargo Extended, 6.6 6SECTION Installation Procedure
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Paint the rear object sensor. Refer to Basecoat/Clearcoat Paint Systems .
- Ensure the paint does not exceed 6 mils. Use a paint thickness gauge suitable for non-ferrous metals. Refer to Paint Gages .
- Insert the sensor into the housing.
- Connect the electrical connector to the rear object sensor.
IMPORTANT:
Do not refinish previously painted sensors. Excess paint build up will cause the sensor to be inoperative.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.