Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2010SAVANA G2500, VAN CARGO EXTENDED, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1044 (OBJECT DETECTION SYSTEM)REPAIR INSTRUCTIONSOBJECT ALARM MODULE REPLACEMENT
2010 GMC Savana G2500, Van Cargo Extended, 6.6 6
Object Alarm Module Replacement
2010 GMC Savana G2500, Van Cargo Extended, 6.6 6SECTION Object Alarm Module Replacement
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Object Alarm Module Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure: Remove the front passenger bucket seat. Refer to Front Seat Replacement - Bucket . |
|
| 1 | Rear Object Alarm Module Nut (Qty: 3)
NOTE:
Refer to Fastener Notice
.
Tighten: 9 N.m (80 lb in) |
| 2 | Rear Object Alarm Module Assembly Procedure
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.