Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2010SAVANA 4500 V8-6.6L DSL TURBOREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSAIR FLOW METER/SENSORSERVICE AND REPAIRVIN 6
2010 GMC Savana 4500 V8-6.6L DSL Turbo
VIN 6
2010 GMC Savana 4500 V8-6.6L DSL TurboSECTION VIN 6
Mass Airflow Sensor with Intake Air Temperature Sensor Replacement
Removal Procedure
1. Disconnect the mass air flow (MAF)/intake air temperature (IAT) sensor electrical connector.
2. Remove the MAF/IAT sensor TORX(R) screws.
3. Remove the MAF/IAT sensor.
Installation Procedure
1. Install the MAF/IAT sensor.
Caution: Refer to Fastener Caution (Fastener Caution).
2. Install the MAF/IAT sensor TORX(R) screws and tighten to 8 Nm (70 lb in).
3. Connect the MAF/IAT sensor electrical connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.