Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2010SAVANA 3500 V8-6.0LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMCRANKSHAFT POSITION SENSORLOCATIONSPOWERTRAIN COMPONENT VIEWS
2010 GMC Savana 3500 V8-6.0L
Powertrain Component Views
2010 GMC Savana 3500 V8-6.0LSECTION Powertrain Component Views
Powertrain Component Views
Front of the Engine (LU3)
1 - Generator
2 - A/C Compressor Clutch Connector (C60)
3 - Crankshaft Position (CKP) Sensor
Right Side of the Engine Components (L20, LMF or L96)
1 - Ignition Coil 8
2 - Ignition Coil 6
3 - Ignition Coil 4
4 - Manifold Absolute Pressure (MAP) Sensor
5 - Throttle Body
6 - Ignition Coil 2
7 - Knock Sensor (KS) 2
8 - Crankshaft Position (CKP) Sensor
9 - Starter
10 - Engine Oil Pressure (EOP) Sensor
Right Side of the Engine (L20, LMF or L96)
1 - Crankshaft Position (CKP) Sensor Connector
2 - A/C Compressor Clutch Connector (C60)
3 - Starter Motor
Right Front of Engine Components (LGH)
1 - Fuel Injector 7
2 - Fuel Injector 5
3 - Exhaust Aftertreatment Fuel Injector
4 - Exhaust Temperature Sensor 1
5 - Fuel Injector 1
6 - Turbocharger Vane Position Control Solenoid Valve
7 - Exhaust Gas Recirculation (EGR) Temperature Sensor 2
8 - Generator
9 - Manifold Absolute Pressure (MAP) Sensor
10 - Camshaft Position (CMP) Sensor
11 - Crankshaft Position (CKP) Sensor
12 - Engine Block Heater
13 - Glow Plug 1
14 - Glow Plug 3
15 - Starter Motor
16 - Glow Plug 5
17 - Glow Plug 7
18 - Fuel Injector 3
Right Side of the Engine (LMM)
1 - Fuel Injector 7
2 - X112
3 - Fuel Injector 5
4 - Fuel Injector 3
5 - Exhaust Gas Recirculation (EGR) Valve
6 - Fuel Injector 1
7 - Generator
8 - Intake Air Valve
9 - X108
10 - Camshaft Position (CMP) Sensor
11 - Crankshaft Position (CKP) Sensor
12 - G108
13 - G104
14 - Starter Motor
15 - Glow Plug 1
16 - Glow Plug 3
17 - Glow Plug 5
18 - Glow Plug 7
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.