Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2009SAVANA G2500, VAN CARGO EXTENDED, 6.6 6REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTEXTERIOR LIGHTSLIGHTING SYSTEMSDIAGNOSTIC INFORMATION AND PROCEDURESDTC B1480CIRCUIT/SYSTEM TESTING
2009 GMC Savana G2500, Van Cargo Extended, 6.6 6
Circuit/System Testing
2009 GMC Savana G2500, Van Cargo Extended, 6.6 6SECTION Circuit/System Testing
- Ignition OFF, disconnect the X3 harness connector at the BCM.
- Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal 2 and ground.
- If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal, and the B+ circuit fuse is open, test the control circuit and components listed below for a short to ground. If all circuits and components test normal, replace the BCM.
BCM Harness Connector X2 Terminal 1
- Underhood Lamp
- Front Courtesy/Reading Lamp
- Middle Courtesy/Reading Lamp
- Rear Courtesy/Reading Lamp
- Left Sunshade Lamp
- Right Sunshade Lamp
- If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal, and the B+ circuit fuse is open, test the control circuit and components listed below for a short to ground. If all circuits and components test normal, replace the BCM.
- If all circuits test normal, replace the BCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.