SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2009CANYON 4D PICKUP, 2.9 9REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 6 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 5.3L - INTRODUCTION, SERVICE & REPAIR)REPAIR INSTRUCTIONSIGNITION COIL REPLACEMENTREMOVAL PROCEDURE
2009 GMC Canyon 4D Pickup, 2.9 9

Removal Procedure

2009 GMC Canyon 4D Pickup, 2.9 9SECTION Removal Procedure
WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Spark Plug Wires At Ignition Coil
    GM344169Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold cover. Refer to Upper Intake Manifold Sight Shield Replacement .
  2. Remove the spark plug wire from the ignition coil.
    3. Fig 2: View of Ignition Coil Harness Connector
    GM339299Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the ignition coil electrical connector.
    4. Fig 3: View Of Ignition Coil Mounting Bolts
    GM344167Courtesy of GENERAL MOTORS CORP.
  4. Remove the ignition coil bolts.
    5. Fig 4: View Of Ignition Coils & Spark Plug Wires
    GM339300Courtesy of GENERAL MOTORS CORP.
  5. Remove the ignition coil.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.