Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSGMC2009CANYON 4D PICKUP, 2.9 9REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 6 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 5.3L - INTRODUCTION, SERVICE & REPAIR)REPAIR INSTRUCTIONSFUEL LEVEL SENSOR REPLACEMENTINSTALLATION PROCEDURE

2009 GMC Canyon 4D Pickup, 2.9 9

Installation Procedure

2009 GMC Canyon 4D Pickup, 2.9 9SECTION Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Fuel Level Sensor

Courtesy of GENERAL MOTORS CORP.

Complete the following in order to install the fuel level sensor to the module bucket.
1. Align the edges of the sensor with the slots in the module bucket.
2. Slide the sensor down into position, ensure the locking tabs are fully engaged.

Fig 2: View Of Fuel Tank Module

Courtesy of GENERAL MOTORS CORP.

Connect the fuel level sensor electrical connector (1) to the module cover.
Install the fuel tank module. Refer to Fuel Tank Fuel Pump Module Replacement .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.