Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2009CANYON 4D PICKUP, 2.9 9REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 6 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 5.3L - INTRODUCTION, SERVICE & REPAIR)REPAIR INSTRUCTIONSENGINE COOLANT TEMPERATURE SENSOR REPLACEMENTREMOVAL PROCEDURE
2009 GMC Canyon 4D Pickup, 2.9 9
Removal Procedure
2009 GMC Canyon 4D Pickup, 2.9 9SECTION Removal Procedure
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.
- Drain the cooling system below the level of the ECT sensor. Refer to Cooling System Draining and Filling (Static Fill) or Cooling System Draining and Filling (Vac N Fill) .
- Disconnect the engine wiring harness electrical connector (1) from the engine coolant temperature (ECT) sensor.
- Remove the ECT sensor (1).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.