Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2009CANYON 4D PICKUP, 2.9 9REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 11 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 5.3L - DTC P0016 TO DTC P0308)DTC P0016CIRCUIT/SYSTEM TESTING
2009 GMC Canyon 4D Pickup, 2.9 9
Circuit/System Testing
2009 GMC Canyon 4D Pickup, 2.9 9SECTION Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
You must perform the Circuit/System Verification before proceeding with Circuit/System Testing.
- Inspect the engine front cover area, or review the service history of the vehicle for any recent repairs involving the timing chain, timing chain tensioner, camshaft, crankshaft, camshaft actuator, or sprockets.
- If recent repairs were made, refer to Camshaft Timing Chain and Sprocket Replacement , and inspect the timing chain, timing chain tensioner, and both sprockets for proper timing alignment or indexing.
- Remove the engine front cover, refer to Engine Front Cover Replacement
and inspect the timing chain, timing chain tensioner, and sprockets for wear or damage. Refer to Camshaft Timing Chain and Sprocket Cleaning and Inspection
.
- If any components are worn or damage, replace as necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.