Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Verification
2009 GMC Canyon 4D Pickup, 2.9 9SECTION Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
The scan tool control of the CMP actuator is inhibited when DTC P0016 or P0017 sets.
- Operate the vehicle at idle and at various engine speeds and load ranges while observing the CMP Variance, Desired CMP, and CMP Angle parameters with a scan tool.
- The CMP Variance should remain less than or equal to 1 degree unless the CMP actuator is being commanded. If the CMP actuator is commanded, the CMP Variance will rise for 1-2 seconds until the CMP Angle parameter matches the Desired CMP parameter. The CMP Variance should again return to less than or equal to 1 degree.
- If the CMP Variance remains more than 1 degree for more than 3 seconds, continue with the Circuit/System Testing.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.