Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2009CANYON 4D PICKUP, 2.9 9REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 3.7L - INTRODUCTION, SERVICE & REPAIR)REPAIR INSTRUCTIONSCRANKSHAFT POSITION SENSOR REPLACEMENTINSTALLATION PROCEDURE
2009 GMC Canyon 4D Pickup, 2.9 9
Installation Procedure
2009 GMC Canyon 4D Pickup, 2.9 9SECTION Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install new O-ring seals to the CKP sensor.
- Lightly lubricate the O-ring seals with clean engine oil.
- Install the CKP sensor into the engine block.
- Add sealer GM P/N 12346004 (Canadian P/N 10953480) to the CKP sensor bolt threads.
- Install the CKP sensor bolt.
Tighten: Tighten the CKP sensor bolt to 10 N.m (89 lb in).
- Connect the engine wiring harness electrical connector (3) to the CKP sensor (1).
- Lower the vehicle.
- Perform the CKP System Variation Learn Procedure. Refer to Crankshaft Position System Variation Learn .
CAUTION:
Refer to Fastener Caution
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.