SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2009CANYON 4D PICKUP, 2.9 9REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 3.7L - INTRODUCTION, SERVICE & REPAIR)REPAIR INSTRUCTIONSCAMSHAFT POSITION SENSOR REPLACEMENT - INTAKEINSTALLATION PROCEDURE
2009 GMC Canyon 4D Pickup, 2.9 9

Installation Procedure

2009 GMC Canyon 4D Pickup, 2.9 9SECTION Installation Procedure
WARNING: This page is about a different variant/trim than selected.
  1. Lightly lubricate the O-ring seal with clean engine oil.
    2. Fig 1: View Of Intake Camshaft Sensor
    GM858173Courtesy of GENERAL MOTORS CORP.
  2. Install the intake CMP sensor into the cylinder head.
  3. Add sealer GM P/N 12346004 (Canadian P/N 10953480) to the CMP sensor bolt threads.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the intake CMP sensor bolt.

    Tighten:  Tighten the CMP sensor bolt to 10 N.m (89 lb in).

    5. Fig 2: View Of Intake CMP Sensor Engine Wiring Harness Connector
    GM1350719Courtesy of GENERAL MOTORS CORP.
  5. Connect the engine wiring harness electrical connector to the intake CMP sensor.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.