SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2009CANYON 4D PICKUP, 2.9 9REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 76 (POWER SEAT SYSTEM)REPAIR INSTRUCTIONSPOWER SEAT SWITCH REPLACEMENTREMOVAL PROCEDURE
2009 GMC Canyon 4D Pickup, 2.9 9

Removal Procedure

2009 GMC Canyon 4D Pickup, 2.9 9SECTION Removal Procedure
WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat cushion outer trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
  2. Remove the switch bezel from the seat assembly. Refer to Driver Seat and Passenger Seat Adjuster Switch Bezel Replacement .
  3. Remove the buttons from the switch (2).
    4. Fig 1: View Of Lumbar Switch & Power Seat Switch
    GM1333646Courtesy of GENERAL MOTORS CORP.
  4. Release the tabs (1) that retain the seat switch (2) to the seat bezel.
    5. Fig 2: View Of Switch Harness
    GM1333639Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the power seat switch harness (1) from the seat harness.
  6. Remove the power seat switch from the seat bezel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.