Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2009CANYON 4D PICKUP, 2.9 9REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 76 (POWER SEAT SYSTEM)REPAIR INSTRUCTIONSLUMBAR SWITCH REPLACEMENTINSTALLATION PROCEDURE
2009 GMC Canyon 4D Pickup, 2.9 9
Installation Procedure
2009 GMC Canyon 4D Pickup, 2.9 9SECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the lumbar switch harness (1) to the seat harness.
- Install the lumbar switch (3) to the seat bezel. Verify that the retaining tabs (4) are fully seated.
- Install the buttons on the switch.
- Install the switch bezel assembly to the seat assembly. Refer to Driver Seat and Passenger Seat Adjuster Switch Bezel Replacement .
- Install the seat cushion outer trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.