SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2009CANYON 4D PICKUP, 2.9 9REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 28 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSTRANSFER CASE SHIFT CONTROL MODULE X1
2009 GMC Canyon 4D Pickup, 2.9 9

Transfer Case Shift Control Module X1

2009 GMC Canyon 4D Pickup, 2.9 9SECTION Transfer Case Shift Control Module X1
WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Transfer Case Shift Control Module X1 Connector End View
GM1334450Courtesy of GENERAL MOTORS CORP.
Transfer Case Shift Control Module X1

Pin Wire Circuit Function
1 0.5 BK 2050 Ground
2 0.5 RD 1553 Motor Control B
3 0.5 BK 1552 Motor Control A
4 0.35 L-BU 1296 Axle Actuator - Control
5-6 - - Not Used
7 0.35 D-GN/WH 1559 4-LO Switch - Signal
8 0.5 OG 1540 Battery Positive Voltage
9 0.5 BK 2050 Ground
10 0.35 L-GN/BK 1563 2-HI Indicator - Control
11 0.35 TN/BK 1566 4-HI Indicator - Control
12 0.35 PU/WH 1565 4-LO Indicator - Control
13 0.35 BN 1560 Neutral Indicator Control
14 0.35 L-BU 1693 Switch Signal Low
15-16 - - Not Used
Connector Part Information 
  • OEM: 15383128
  • Service: 88953423
  • Description: 16-Way F (BK)
Terminal Part Information 
  • Terminal/Tray: 173716-1/7
  • Core/Insulation Crimp: E/4
  • Release Tool/Test Probe: 15315247/J-35616-16 (L-GN)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.