Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Blower Motor Resistor Assembly
2009 GMC Canyon 4D Pickup, 2.9 9SECTION Blower Motor Resistor Assembly
WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
Blower Motor Resistor Assembly
| Pin | Wire | Circuit | Function |
|---|---|---|---|
| A | 2 TN | 63 | Blower Motor Medium 1 Control |
| B | 2 L-BU | 72 | Medium 2 Blower Motor Control |
| C | 2 OG | 52 | Blower Motor High Control |
| D | 2 YE | 60 | Blower Motor Low Control |
Connector Part Information
|
Terminal Part Information
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.