SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2009CANYON 4D PICKUP, 2.9 9REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 11 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)REPAIR INSTRUCTIONSRADIO REAR SIDE DOOR SPEAKER REPLACEMENTINSTALLATION PROCEDURE
2009 GMC Canyon 4D Pickup, 2.9 9

Installation Procedure

2009 GMC Canyon 4D Pickup, 2.9 9SECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Speaker Electrical Connector - Rear
    GM1276816Courtesy of GENERAL MOTORS CORP.
  1. Connect the speaker electrical connection.
    2. Fig 2: View Of Speaker - Rear
    GM1276815Courtesy of GENERAL MOTORS CORP.
  2. Install the two tabs on the speaker into the slots in the door.
    3. NOTE: Refer to Fastener Notice .
  3. Install the screw securing the speaker to the door.

    Tighten:  Tighten the rear door speaker screw to 2.5 N.m (22 lb in).

  4. Install the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.