Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGMC2009CANYON 4D PICKUP, 2.9 9REPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM & FUEL SYSTEM - 2.9L - INTRODUCTION, SERVICE & REPAIRREPAIR INSTRUCTIONSFUEL HOSE/PIPES REPLACEMENT - CHASSISINSTALLATION PROCEDURE
2009 GMC Canyon 4D Pickup, 2.9 9
Installation Procedure
2009 GMC Canyon 4D Pickup, 2.9 9SECTION Installation Procedure
- Position the chassis fuel feed line (2) to the vehicle.
- Engage the fuel feed line to the clips (1).
- Connect the chassis fuel feed line quick connect fitting to the fuel tank line. Refer to Plastic Collar Quick Connect Fitting Service .
- Connect the chassis fuel feed line quick connect fitting (2) to the engine line. Refer to Plastic Collar Quick Connect Fitting Service .
- Lower the vehicle.
- Inspect for leaks using the following procedure:
- Turn ON the ignition, with the engine OFF for 2 seconds.
- Turn OFF the ignition, for 10 seconds.
- Turn ON the ignition, with the engine OFF.
- Inspect for fuel leaks.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.